Cash Register Error Codes

Error Code	Meaning	Action
E01, E001	Mode switch position changed before finalization	Return the mode switch to its original setting (does not beep) and finalize the operation
E03, E003	The signed on clerk differs from the clerk who performed the tracking check registration	Input the correct check number or assign the proper clerk number
E004	Initialization or unit lock clear operation in progress	Complete operation
E08,E008 (SIGN-ON)	Registration without entering a clerk number/ Sign on operation is not performed	Enter a clerk number
E10 (PRINT-LID)	Platen arm of the printer is opened	Close the platen arm
E010	Registration is made while cash drawer is open. The drawer is left open longer than the program time	Close the cash drawer
E11, E011 (DRW-OPEN)	Registration is made while cash drawer is open	Close the cash drawer
E12 (JPAP-END)	Journal Paper end	Replace the paper roll
E14 (RPAP-END)	Receipt Paper end	Replace the paper roll
E015	Printer Error	Turn the power off, remove the jammed paper
E016	Two consecutive transactions attempted in the refund mode	Switch to another mode, and then back to the RF mode for the next transaction
E17	Attempt made to register an item without inputting a table number	Input a table number
E19	Registration without inputting number of customers	Input number of customers
E27 (BUF-FULL)	Transaction cancel, buffer full	Finalize the transaction
E029	Item registration is prohibited , while partial tender	Finalize the transaction
E31, E031 (PRESS-ST)	Finalization of a transaction attempted without confirming the subtotal	Press the [SUBTOTAL] key
E33, E033 (TEND-AMT)	Finalize operation attempted without entering amount tender	Enter the amount tendered
E35, E035 (CNG-OVER)	Change amount exceeds preset limit	Input amount tendered again
E036	Contents of the drawer exceed programmed limit	Perform pickup operation
E037	High amount lock out/ low digit lockout error	Enter correct amount
E38, E038 (DECL-AMT)	Read/reset operation without declaring cash in drawer	Perform money declaration
E40	Attempt made to finalize a transaction without issuing a guest receipt	Issue a guest receipt
E041	Validation is not performed	Perform validation operation
E046	Registration buffer full	Finalize the transaction
E50	Check tracking memory full	Finalize and close the check number currently used
E51	Attempt made to use the New Check key to open a new check number that is already used for an existing check in the check tracking memory	Finalize and close the check that is currently under the number that you want to use or use a different check number
E53	Attempt made to use the Old Check key to open a new check using a number that is not used for an existing check in check tracking memory	Use the correct check number or use the New Check key to open a new check
E075	Attempt to finalize a transaction when balance is less than or equal to zero	Register item(s) until the balance becomes positive amount
E94	Printer Error	Turn the power off, remove the jammed paper
E139	Attempt to register - when the balance becomes negative	Enter proper minus amount
FERR 26	Fatal Main Board Error, Must be serviced