Tax table programming for menu driven entry-level cash registers

PCR-T500, PCR-T520, PCR-T2300, PCR-T2400, SE-S800, SE-S900
PCR-T540, PCR-T560, PCR-T2500, PCR-T2600, SR-S820, SR-S920

TO PROGRAM TAX PERCENTAGE:

Turn the mode switch to PGM position. Use the cursor keys to scroll down to "Tax Setting", then press CA/AMT TEND. You should see a menu with three choices: "Rate", "Round", and "Cal Type".

Highlight "Rate", then press CA/AMT TEND. You should see three taxes listed (or four taxes for Canadian models), each with a percentage. For each tax that you need, highlight the tax rate, type in the proper percentage (for example, if you want 8.25%, type "8.25"), then press the CA/AMT TEND key. When you are done entering all of your taxes in this manner, press SUBTOTAL to go back to the previous menu.

Scroll to "Round" and press CA/AMT TEND. You should again see three taxes. Highlight tax 1, press CA/AMT TEND, and you should see a menu with three choices: "ROUND OFF", "CUT OFF", and "ROUND UP". Highlight "ROUND OFF" and press CA/AMT TEND. You should also make the same settings for taxes 2 and 3 if necessary. When all of the taxes that you need have been set to "ROUND OFF", press SUBTOTAL to return to the previous menu.

Scroll to "Cal Type" and press CA/AMT TEND. You should again see three taxes. Highlight tax 1, press CA/AMT TEND, and you should see a menu with three choices: "ADD ON", "ADD IN", and "NON". Highlight "ADD ON" and press CA/AMT TEND. You should also make the same settings for taxes 2 and 3 if necessary. When all of the taxes that you need have been set to "ADD ON", press SUBTOTAL to return to the previous menu. Finally, press SUBTOTAL again to return to the main menu.

TO PROGRAM STATUS OF DEPARTMENT KEYS:

1. Turn the mode switch to PGM position. The display shows the top screen of programming.
2. Using the cursor up or cursor down keys, select "DEPT Setting", then press CA/AMT TEND. The display shows "DEPT Setting" screen.
3. Enter the department number, then press the CA/AMT TEND key. The display shows the department selection screen. You can change the department by using the cursor up or cursor down keys.
4. Press CA/AMT TEND. The display shows the program input screen.
   
5. Select "Taxable Status" and press the CA/AMT TEND key. The display shows the taxable status selection menu. Choose the taxable status that you want, and press the CA/AMT TEND key.
   
6. Press SUBTOTAL.